Pro SP Racing F3 Competition Flight Controller Acro 6 DOF for DIY Mini 250 280 210 RC Quadcopter FPV Multicopter Drone Better CC3D NAZE32
There are 2 versions optional, This one is Acro Version, If request Deluxe, Please search our store or contact us.
Acro Version: Standard model for racing/ acro flying
Deluxe Version: Additional sensors for altitude and direction
Acro 6DOF Version
1 x Upgrade NAZE32 SP Racing F3 Flight Control for Multicopter
2 x 8p Wire Rod
2 x 4p Extension Path
5 x Pins set
1 x Protective Case
Better coding practices and introducing tests, easier to maintain and for future development. (Dominic has software development background)
Many bugs fixed from Baseflight.
Supports more flight controllers, including CC3D, CJMCU and Sparky.
Supports OneShot ESC and more than 8 RC channels.
Additional PID controllers that uses floating point arithmetic operations. (now has 3 built-in PID Controllers)
Many more features such as RGB LED strip support, Autotune, In-flight PID tuning with your radio, blackbox flight data logging etc.
* 36x36mm board, 30.5 mm mounting holes.
* STM32F3 CPU.
* High-capacity Flash (Acro 6DOF and Deluxe 10DOF)
* MPU6050 Accelerometers and Gyroscopes
* MS5611 Barometer (Deluxe 10DOF) – Not included
* HMC5883 (Deluxe 10DOF) – Not included
* MicroUSB socket.
* 4 x 4 pin JST-SH Socket (I2C, SWD, 2xuart)
* 2 x 8 pin JST-SH Socket (PPM, PWM, SERIAL RX, GPIO, ADC, 3V, 5V, GND)
* 8 x 3 pin though-holes for pin headers for ESC / Servo connections.
* 2 x 4 pin though-holes for the 2x serial ports .
* 2 x 2 pin though-holes for battery voltage and buzzer.
The SPR F3 builds on tried and tested software, processor and sensor technology to make your aircraft fly like it\’s on rails.
Use all the features all the time; e.. Connect your OSD + SmartPort + + GPS + LED Strip + Battery Monitoring + Sonar + 8 motors – all at the same time!
The SP F3 runs Cleanflight which can be configured to suit your needs using a cross-platform GUI (/OSX/Linux).
Tiny and lightweight
The RacingF3 has a standard 36x36mm form-factor with 30.5mm mounting holes and weighs just 6 grams.
On-board high-capacity black box flight log recorder – optimize your tuning and see the results of your setup without guesswork.
The RacingF3 has an ARM Cortex-M4 72Mhz CPU with Math co-processor (FPU) for efficient flight calculations that gets more done in less time.
Loop times up to ~2x as fast as previous-generation STM32F1 based boards.
Developer friendly debugging port (SWD) and boot mode selection, unbrickable bootloader.
Full support for OneShot ESCs for easy PID tuning and a sharper response.
Broad RC receiver Support
Supports , SumH, SumD, Spektrum1024/2048, XBus, PPM, PWM receivers. No external inverters required (built-in).
Dedicated output for programmable LEDs – great for orientation, racing and night flying.
Battery monitoring ports for voltage and current.
Sonar support for precision low-altitude hold.
I2C port powered, perfect for external sensors or -on OLED Screen.
Buzzer port for audible warnings and notification